Solid Modeled Assembly -(Group 10)
From GICLWiki
(Difference between revisions)
| Line 1: | Line 1: | ||
[[Gate 3 - Product Analysis (Group 10)]] | [[Gate 3 - Product Analysis (Group 10)]] | ||
| + | |||
| + | |||
| + | == '''Introduction''' == | ||
| + | Our 3D CAD Modeling was modeled and Assembled in Autodesk Inventor. We picked these parts because of there important role in the Engine sub-system that they play. These components also allowed us to create two sub-assembolies which are a part of a greater assemboly, and also let us view the more complex parts which we talked about in the Product analysis, letting us see how changes in a part changes other aassemboly dimentions and constrains. | ||
Revision as of 17:36, 16 November 2012
Gate 3 - Product Analysis (Group 10)
Contents |
Introduction
Our 3D CAD Modeling was modeled and Assembled in Autodesk Inventor. We picked these parts because of there important role in the Engine sub-system that they play. These components also allowed us to create two sub-assembolies which are a part of a greater assemboly, and also let us view the more complex parts which we talked about in the Product analysis, letting us see how changes in a part changes other aassemboly dimentions and constrains.
Piston
Part #68
3D CAD Modeling
Drive Shaft and Gear Assemboly
Part #50
Drive shaft Parts
Drive Shaft Assemboly
Piston Arm Assemboly
Part #66
Piston Arm Linkage
Linkage
Linkage Shackel
Linkage Assemboly
Engine Block
System Assemboly
Piston Cycle
