Group 6 - Kobalt 1/2 in Impact Wrench
| Line 17: | Line 17: | ||
[[Gate 3 - Product Overview and Analysis - Group 6 2012| Gate 3 ]] is where the group did further analysis on the dissected impact wrench. | [[Gate 3 - Product Overview and Analysis - Group 6 2012| Gate 3 ]] is where the group did further analysis on the dissected impact wrench. | ||
| − | == Gate 4 == | + | == Gate 4 - Product Explanation and Reassembly == |
| + | [[Gate 4 - Product Explanation and Reassembly - Group 6 2012| Gate 4 ]] discusses the mechanisms of the impact wrench. It also goes through the reassembly of the wrench and discusses possible design revisions. | ||
Revision as of 19:55, 29 November 2012
For our dissection we chose a Kobalt 1/2" pneumatic impact wrench. We chose a pneumatic wrench rather than an electric wrench because we were interested in the differences in efficiencies between the models. We will look at how the design was influenced by various factors and will examine the overall complexity of the tool.
Contents |
Group Members
John Pfalzer
Amie Vuong
Kyle Schmidt
Michael Wrona
Spencer Heyden
Gate 1 - Project Planning
Gate 1 is the planning phase for the project. It contains a management proposal and the product archaeology.
Gate 2 - Project Dissection
Gate 2 is where the group took the impact wrench apart. It contains challenges faced and product archaeology
Gate 3 - Product Analysis
Gate 3 is where the group did further analysis on the dissected impact wrench.
Gate 4 - Product Explanation and Reassembly
Gate 4 discusses the mechanisms of the impact wrench. It also goes through the reassembly of the wrench and discusses possible design revisions.
