Group 24 - Toro Snowblower 2

Figure 1 :CCR 1000 Snow Thrower [1]

University at Buffalo MAE 277

Introduction

This page contains the first gate of group 24’s MAE 277 project. The purpose of this project is to present the information that is accumulated through our research and dissection. During the course of this project, our group will assemble and disassemble a 20 inch 3.5 horse power snow blower. All of the information collected during the disassembly and reassembly of the snow blower will be organized and documented on this wiki page.

Group member	E-mail
Chris Chase	cdchase@buffalo.edu
Eric Bailen	ericbail@buffalo.edu
Josh Ulrich	joshuaul@buffalo.edu
Ryan Scall	ryanscal@buffalo.edu
Cormac Canales	Dropped class
Tom Oates	Dropped class

Project Gates

Gate 1: Preliminary Design Review

-Work Proposal
-Management Proposal
-Initial Assessment

Gate 1 Content

Gate 2: Product Dissection

-Preliminary Project Review
-Product Dissection
-Product Dissection Assessment

Gate 2 Content

Gate 3: Product Analysis

-Coordination Review
-Product Evaluation
Gate 3 Content

Gate 4: Product Explanation

-Reasembly

Gate 4 Content