Gate 4 - Group 15 - 2012
(→Product Assembly Guide) |
(→Product Assembly Guide) |
||
| Line 16: | Line 16: | ||
==='''Product Assembly Guide'''=== | ==='''Product Assembly Guide'''=== | ||
| + | |||
| + | ====Ease of Reassembly==== | ||
| + | |||
| + | ====Assembly Guide==== | ||
{| border="1" | {| border="1" | ||
| Line 142: | Line 146: | ||
'''Total Assembly Time: _ hour and _ minutes''' | '''Total Assembly Time: _ hour and _ minutes''' | ||
| + | |||
| + | ====Product Assembly Challenges==== | ||
==='''Mechanisms'''=== | ==='''Mechanisms'''=== | ||
==='''Design Revisions'''=== | ==='''Design Revisions'''=== | ||
Revision as of 23:51, 26 November 2012
Contents |
Introduction
The purpose of the fourth gate was gain a better understanding for how the device used its parts to generate motion and to create design changes for the circular saw on a system level. To accomplish this, a complete reassembly of our product was done and each step was recorded in detail to be used in later analysis. This was crucial because it helped to gain an understanding in how each of the parts were assembled in accordance to the kind of motion they would be responsible for producing. In addition, this was also important when considering design revisions because they would ultimately impact the assembly process of the product.
Project Management: Coordination Review
Cause for Corrective Action
Product Archaeology: Product Explanation
In order to assemble the product, the following tools are needed;
- T20 Torx Screwdriver
- 13 mm Torque Wrench
- Hammer
- Hands
Product Assembly Guide
Ease of Reassembly
Assembly Guide
| Step # | Description | Tool Required | Difficulty Level | Photograph |
| 1 | File:Group15F2012step1a | |||
| 2 | File:Group15F2012step2a | |||
| 3 | File:Group15F2012step3a | |||
| 4 | File:Group15F2012step4a | |||
| 5 | File:Group15F2012step5a | |||
| 6 | File:Group15F2012step6a | |||
| 7 | File:Group15F2012step7a | |||
| 8 | File:Group15F2012step8a | |||
| 9 | File:Group15F2012step9a | |||
| 10 | File:Group15F2012step10a | |||
| 11 | File:Group15F2012step11a | |||
| 12 | File:Group15F2012step12a | |||
| 13 | File:Group15F2012step13a | |||
| 14 | File:Group15F2012step14a | |||
| 15 | File:Group15F2012step15a | |||
| 16 | File:Group15F2012step16a | |||
| 17 | File:Group15F2012step17a | |||
| 18 | File:Group15F2012step18a | |||
| 19 | File:Group15F2012step19a |
Figure 1. Step by step assembly guide
Total Assembly Time: _ hour and _ minutes
