Gate 4 - Group 15 - 2012
From GICLWiki
(Difference between revisions)
(Created page with "===Introduction=== == Project Management: Coordination Review == ==='''Cause for Corrective Action'''=== == Product Archaeology: Product Evaluation == ==='''Product Reasse...") |
(→Introduction) |
||
| Line 1: | Line 1: | ||
===Introduction=== | ===Introduction=== | ||
| + | |||
| + | The purpose of the fourth gate was gain a better understanding for how the device uses its parts generate motion and to create three design changes for the circular saw on a system level. To accomplish this, a complete reassembly of our product was done and each step was recorded in detail to be used in later analysis. This was crucial because it helped to gain an understanding in how each of the parts were assembled in accordance to the kind of motion they would be responsible for producing. In addition, this was also important when considering design revisions because they would ultimately impact the assembly process of the product. | ||
== Project Management: Coordination Review == | == Project Management: Coordination Review == | ||
Revision as of 23:37, 26 November 2012
Contents |
Introduction
The purpose of the fourth gate was gain a better understanding for how the device uses its parts generate motion and to create three design changes for the circular saw on a system level. To accomplish this, a complete reassembly of our product was done and each step was recorded in detail to be used in later analysis. This was crucial because it helped to gain an understanding in how each of the parts were assembled in accordance to the kind of motion they would be responsible for producing. In addition, this was also important when considering design revisions because they would ultimately impact the assembly process of the product.
