Exceed RC Buggy Solid Modeling

From GICLWiki
Revision as of 21:39, 18 December 2011 by MAE 277 2011 Group14 (Talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Solid Modeled Assembly

When deciding which subsystem to model, we decided to use the engine as it is the primary source of work for this car and the function of the car hinges on its performance. The entire engine subsystem consists of a pull starter, chamber cover, shaft, two supports, an outlet for exhaust, a glow plug, and the single-cylinder engine itself. The sizes of these components, as well as their arrangement is shown in the images below. The individual components and final assembly drawing were created in AutoCAD 2011 Student Version.

  • Figure 20: Gallery of individual CAD drawings

  • Engine block

  • Exhaust manifold

  • Glow plug

  • Lock nut

  • Starter shaft

  • Engine support

  • Chamber cover

  • Pull starter


*Note: Fasteners were not included in this block assembly due to time constraints.

RCassem1.png
Figure 21: Exploded right side view
RCassem2.png
Figure 22: Exploded rear view
RCassem3.png
Figure 23: Fully assembled view of the engine subsystem
Retrieved from "http://gicl.cs.drexel.edu/wiki-data/index.php?title=Exceed_RC_Buggy_Solid_Modeling&oldid=176137"
Personal tools