Difference between revisions of "Black and Decker Dustbuster"

From GICL Wiki
Jump to: navigation, search
Line 12: Line 12:
 
* Capacity of dirt chamber – want the chamber to have large capacity so that the holding chamber does not have to be replaced too  frequently
 
* Capacity of dirt chamber – want the chamber to have large capacity so that the holding chamber does not have to be replaced too  frequently
 
* Nozzle attachments – for different types of cleaning (wet/dry, big things/small, etc.)
 
* Nozzle attachments – for different types of cleaning (wet/dry, big things/small, etc.)
* variable speeds – This is useful when cleaning different surfaces
+
* Variable speeds – This is useful when cleaning different surfaces
 
* Ease of replacement/cleaning of filter – This process should be as easy as possible
 
* Ease of replacement/cleaning of filter – This process should be as easy as possible
 
* Release button (for nozzle) – want this to be easy to use and easy to find
 
* Release button (for nozzle) – want this to be easy to use and easy to find

Revision as of 23:33, 30 January 2008

Function

This device has been made by Black and Decker and is a cordless vacuum cleaner that is used to suck up unwanted waste and fine particles. This was one of the most successful vacuum cleaners ever made by the company. The function is accomplished by the vacuum inside which sucks the dirt through the nozzle into the holding chamber.

Whole9.JPG

Some possible user requirements

  • Suction power – Want it to be large enough to collect all the extraneous particles
  • Size of nozzle(s) – may need a bigger/smaller one depending on different uses
  • Battery/Battery longevity – This is needed so it can be used without a cord and used for a good amount of time as well
  • Weight – Want the Dustbuster to be light enough so that a user’s arm does not get tired holding on to the Dustbuster for even short periods of time
  • Capacity of dirt chamber – want the chamber to have large capacity so that the holding chamber does not have to be replaced too frequently
  • Nozzle attachments – for different types of cleaning (wet/dry, big things/small, etc.)
  • Variable speeds – This is useful when cleaning different surfaces
  • Ease of replacement/cleaning of filter – This process should be as easy as possible
  • Release button (for nozzle) – want this to be easy to use and easy to find


Parts

Listed below is the Bill of Materials for the Black and Decker Dustbuster:

Table 1: Black and Decker Dustbuster Bill of Materials
Part # Part Name Category Function Material Picture
1 Battery Pack Input Powers the vacuum. 8 Recyclable Rechargable Nickel Cadmium batteries with wire and metal connections.
Battery pack.JPG
2 Impeller Output Creates suction for the vacuum. Plastic
Impeller2.JPG
3 Motor with Fan Input Motor spins the impeller while the spinning fan pulls heat from the motor. Steel outer shell with a plastic fan and coils of copper wires
Motor.JPG
4 Speed controller Motion Conversion Element Allows for varying the speed of the motor and impeller. Plastic plates with copper connectors
Switch.JPG
5 Electric Circuitry Input Supplies the appropriate current to the motor. Plastic base with brass connectors and one resistor
Circuit.JPG
6 Outer Plastic Casing Structural Components Protects the inner working parts and provides safety for the user. Plastic
Casing.JPG
7 Motor Shaft Transmission Connects the motor to the impeller and causes the impeller to turn when the motor does. Steel
Shaft.JPG
8 Charging station Input Charges the batteries inside of the dustbuster. Plastic with metal connections
Charging.JPG